Stainless Steel Triglide
For use with harnesses and weightbelts. 2″ x 1.5″
$5.00
CompareRelated products
-
Components and Parts, Cylinder Accessories, Sidemount BCD
EPDM Hose Retainer
The EPDM Hose Retainer will withstand the test of time and diving environments with their resistance to temperature, salt, chlorine, and anything else your diving environment has to offer.
- Keep stage and deco hoses under control
- 1.5-inch wide EPDM material maintains elasticity thru extreme heat and cold
- Resistance to temperature, salt, sun and chlorine
- Fits cylinders 6.9-inch thru 8-inch diameter (11L)
SKU: n/a -
Components and Parts
Sidemount Sliding D-Ring
Sliding D-ring’s are installed on the harness in addition to primary d-rings. Sliding D-ring can be pushed up and down the waist strap to desired by diver location and allows to adjust on-the-fly sidemount cylinder clip off point to compensate the change in tank buoyancy. Its a simple yet durable part that will let sidemount diver keep the cylinders in perfect position throughout entire dive ensuring most streamline and comfort trim profile. The stainless steel sliding d-rings will work with any 2″ wide nylon harness webbing.
SOLD AS PAIR / 2 pcs set
SKU: ODKUS11 -
Components and Parts, Sidemount BCD
MIB Hose Breakaway Connector
The MIB break away connector allows the ease of mounting a single ended bolt snap to your long hose configuration. Traditionally, divers have relied on using cave lines for this but with this, each time you practise your break away, you no longer have to retie your single bolt snap.
The MIB break away connector is easy to use, does not slide on the hose. This breakaway clips are designed for emergency use in the event of an ‘out of air’ scenario. As such they are not designed to hold up to repeated attaching and detaching from the hose. Additionally, the single breakaway clip is designed to fit most single-ended bolt snap ring with a max diameter of 4.5mil.
Trying to attach the clip to a ring with a diameter of more than 4.5mm is not advisable, and will likely cause the clip to break. And finally, repeated attaching and detaching of the single clips when used for something other than a secondary regulator hose runs the risk of reducing the clip’s lifespan.
SKU: n/a -
Components and Parts
Bladder Flange Gasket
This generic Flange Gasket is a Female (outside/thicker/smaller) fitting that is positioned between the elbow and the flange. This is the gasket that creates the watertight seal between the corrugated hose assembly and the bladder for the aircell (wing).
SKU: n/a -
Components and Parts
45-degree Oral Power Inflator – Mouthpiece only
A replacement rubber mouthpiece for the standard K-style 45-degree Oral and Power Inflator.
- A replacement mouthpiece for K-style 45-degree Power Inflator
- Soft rubber material designed for comfort
- Curved design allows for easier seal during use
- Keep a spare in your Save-A-Dive kit
SKU: n/a
