Bladder Flange Gasket
This generic Flange Gasket is a Female (outside/thicker/smaller) fitting that is positioned between the elbow and the flange. This is the gasket that creates the watertight seal between the corrugated hose assembly and the bladder for the aircell (wing).
Related products
-
-
Components and Parts
Sidemount Sliding D-Ring
Sliding D-ring’s are installed on the harness in addition to primary d-rings. Sliding D-ring can be pushed up and down the waist strap to desired by diver location and allows to adjust on-the-fly sidemount cylinder clip off point to compensate the change in tank buoyancy. Its a simple yet durable part that will let sidemount diver keep the cylinders in perfect position throughout entire dive ensuring most streamline and comfort trim profile. The stainless steel sliding d-rings will work with any 2″ wide nylon harness webbing.
SOLD AS PAIR / 2 pcs set
SKU: ODKUS11 -
Components and Parts, Sidemount BCD
MIB Titanium Chest Dual Slot Chest 45º Fixed D-Ring
The MIB Titanium Chest Dual Slot Chest 45º Fixed D-Ring was designed for backmount and sidemount divers. The 45º Fixed angle enable divers to easily clip off their single or doubled ended bolt snaps to it. Made from 2mm titanium so ultra-light and tough. The MIB Titanium Chest Dual Slot Chest 45º Fixed D-Ring has a custom Split D-Ring titanium fitting for chest or waist. Simplifies the placement and separation of bolt snaps holding other equipment.
Item weight is only 15 grams, compared to stainless steel ones which are weighing 28 grams to 37 grams (Tri-glide with Angle D-Rings).
The price listed is per piece.
SKU: n/a -
Components and Parts, Sidemount BCD
MIB Hose Breakaway Connector
The MIB break away connector allows the ease of mounting a single ended bolt snap to your long hose configuration. Traditionally, divers have relied on using cave lines for this but with this, each time you practise your break away, you no longer have to retie your single bolt snap.
The MIB break away connector is easy to use, does not slide on the hose. This breakaway clips are designed for emergency use in the event of an ‘out of air’ scenario. As such they are not designed to hold up to repeated attaching and detaching from the hose. Additionally, the single breakaway clip is designed to fit most single-ended bolt snap ring with a max diameter of 4.5mil.
Trying to attach the clip to a ring with a diameter of more than 4.5mm is not advisable, and will likely cause the clip to break. And finally, repeated attaching and detaching of the single clips when used for something other than a secondary regulator hose runs the risk of reducing the clip’s lifespan.
SKU: n/a -
Components and Parts, Cylinder Accessories, Sidemount BCD
Diverite Deluxe Hose Retainers
Keep regulator hoses lying flat and avoid kinking with our Deluxe Hose Retainers. Our wide, 4-inch (10 cm) retainer band is made of a proprietary, stretch material used in bandages. The material holds up to salt water and dries quickly. Silicone strips on the inside of the band grip the tank and keep the Deluxe Hose Retainer from rolling. A 1″ x 2″ (2.5cm x 5cm) nylon pull tab makes accessing the hose retainer easy, even when using gloves.
Size large (GM2050-7) fits 7.25-inch (184 mm) and 8-inch (203 mm) diameter tanks. Size small (GM2050-5) fits 5.5-inch (127 mm) diameter tanks. Both size retainers come in black only. Made in the U.S.A.
SKU: n/a
