Stainless Steel Triglide
For use with harnesses and weightbelts. 2″ x 1.5″
$5.00
CompareRelated products
-
BCD Pockets
Xdeep Sidemount Trim Pockets L
XDEEP trim pockets can be mounted both to the shoulder straps and to the waist strap. Trimming in sidemount never was so easy.
To make them more comfortable, we put inside the pocket a special reinforcement plate made of highly durable polymer. It makes the weight fit tightly to the strap. Therefore, nothing is loose and nothing bumps.
The XDEEP trim pockets can be used with any sidemount or harness made of 50 mm (2 inch) webbing.
SKU: 59356 -
Components and Parts
Sidemount Sliding D-Ring
Sliding D-ring’s are installed on the harness in addition to primary d-rings. Sliding D-ring can be pushed up and down the waist strap to desired by diver location and allows to adjust on-the-fly sidemount cylinder clip off point to compensate the change in tank buoyancy. Its a simple yet durable part that will let sidemount diver keep the cylinders in perfect position throughout entire dive ensuring most streamline and comfort trim profile. The stainless steel sliding d-rings will work with any 2″ wide nylon harness webbing.
SOLD AS PAIR / 2 pcs set
SKU: ODKUS11 -
Components and Parts
Oxycheq Shoulder Harness Pads
Removable Shoulder Harness Pads go on the shoulder straps of a Hogarthian or Speed Harness Rig. Helps to keep the straps from digging into the shoulders when you are out of the water and the weight of your gear is on your shoulders. The pads are easily installed or removed without having to disassemble the Hogarthian or Speed Harness harness. The pads have a left and right side configuration.
SKU: n/a -
Components and Parts, Sidemount BCD
MIB Hose Breakaway Connector
The MIB break away connector allows the ease of mounting a single ended bolt snap to your long hose configuration. Traditionally, divers have relied on using cave lines for this but with this, each time you practise your break away, you no longer have to retie your single bolt snap.
The MIB break away connector is easy to use, does not slide on the hose. This breakaway clips are designed for emergency use in the event of an ‘out of air’ scenario. As such they are not designed to hold up to repeated attaching and detaching from the hose. Additionally, the single breakaway clip is designed to fit most single-ended bolt snap ring with a max diameter of 4.5mil.
Trying to attach the clip to a ring with a diameter of more than 4.5mm is not advisable, and will likely cause the clip to break. And finally, repeated attaching and detaching of the single clips when used for something other than a secondary regulator hose runs the risk of reducing the clip’s lifespan.
SKU: n/a -
Components and Parts
BCD Shoulder Elbow
The plain BC elbow, preferred by experienced divers, can be used to replace a pull-to-dump elbow. The OEM (Non-Exhaust) Elbow w/Nut
This assembly is compatible with Wing Systems from Dive Rite, DGX, Oxycheq, Light Monkey, HOG, and some other technical wings with an opening of {1.75 in | 4.4 cm}. Not compatible with SeaQuest, Scubapro, Oceanic, Aqualung, Mares, Hollis, Zeagle, OMS and other major brands.
SKU: n/a
